What Is Phase Control On Sonos Sub. From the settings tab, tap system. Setting the phase control to 180 degrees reverses the polarity of the subwoofer.
When the two are in phase, the bass will be louder. First, let me digress a little with an explanation about phase. For your system to be properly in phase, or aligned to this action, your subwoofer needs to have its driver pulse outward on the same kick drum thump.
The Phase Control Chooses What Direction The Sub Speakers Move In Response To An Input Signal.
If your subwoofer and main speakers are in phase, the woofer cones on the subwoofer and the speakers will move forward and backward in sync at the subwoofer crossover frequency. Other than simply turning the sub on or off, you can adjust its volume level relative to the other speakers in the room, switch the phase between 0 or. Tap eq, and then drag the sliders to make adjustments.
Ideally, The Phase Contol Should Be Adjustable From 0 To 180 Degrees Not Just 0 And 180.
If you have an 80 hz crossover, then 180 degrees of phase shift equates to 6.25 ms of delay at 80 hz. Switching the phase can eliminate these nulls. They'll reinforce each other's output.
Adding Delay To The Subwoofer Signal Can Sometimes Help The Subwoofer To Integrate Better With The Loudspeakers In The Room.
A phase 180 is a setting that can be adjusted on some subwoofers in which the polarity of the driver is reversed, meaning that when the cone moves forward, it moves backward. This has been a requested topic from a few of my viewers. What is sub phase control?
Click To See Full Answer.
On ios or android open the sonos app. Setting the phase control to 180 degrees reverses the polarity of the subwoofer. The phase control in a powered subwoofer allows the user to add electrical delay to the incoming signal.
If Your Mixer Has Phase Reverse On The Outputs Or Aux Sends (As Is The Case Some Yamaha Mixers), You Can Flip The Subwoofer’s Phase While Listening To The System From The Mix Position Instead Of Having To Use A Switch On The Sub’s Rear Panel.
So, in this case the phase knob adds delay from 0 to 6.25 ms to the entire signal. From the settings tab, tap system. Since subwoofer sound waves are very large, you can get overlaps in a room that cause nulls in the sound.